Welcome to this auction of a set of high quality PRECISION 7mm HUBCENTRIC SPACER KIT for Porsche and many other cars that have 5 studs per wheel (5x130mm Hub). You will receive 1pair x 7mm Precision (Porsche 71.5mm) Hubcentric Spacers. The Outside Diameter Of These Spacers Is 164mm Vehicles Covered PORSCHE CAYENNE 955 (02-) PORSCHE CAYMAN S (05-) PORSCHE 911 996 (97-05) PORSCHE 911 997 (04-) PORSCHE BOXSTER 986 (96-) PORSCHE BOXSTER 987 (04-) PORSCHE CARRERA GT (03-) Our spacers have been manufactured and designed in house by CreationsMotorsport and are made especially for the Porsche brand of cars. However they may also fit other brands with 5x130mm PCD hubs. These hubcentric spacers have a 71.5mm centre bore on both the internal and external face with an outside diameter of 164mm The recommended bolts for these spacers are M14x1.5x40mm with 60 degree taper seat, these be purchase from our Wheel Bolts section. Our spacers are made out of a single block of 100% aluminium and not welded. These spacers are hubcentric meaning they will sit flush on the hub. At Creations Motorsport We don't sell universal or floating spacers as they cause too much fitment issues and vibrations. The spacers will fit securely onto your wheel hub. The alloy wheel will then fit directly onto our wheel spacer allowing for perfect fitment and no wheel wobble at all unlike other universal spacers. Please make sure your hub lip does not protrude more than 7mm on your wheels. If unsure please ask. Please note due to many issues with customers fitting incorrect spacers to their cars, we have had to put up this disclaimer so that customers understand the importance of correct fitment of spacers. When purchasing our hub centric spacers and as different models of cars come with different hubs, it is the responsibility of the customer to make sure that the hub lip on the hub does not protrude more than the inner diameter of the spacer. For example if you purchase 10mm spacers and your hub lip protrudes by 12mm then you will not be able to fit the 10mm spacers without snapping the ring on the hub centric lip of the spacer. Also please note before fitting any spacers it is imperative that the hub is thoroughly cleaned with a wire brush and greased prior to fitting and please make sure the spacer is sitting flat and the inner face of the wheel does not foul the spacer. If the lip of the hub is 12mm then you need at least a 12mm space inside the spacer to make sure of correct fitment. If you are unsure please ask. Please do not fit spacers until you have checked this measurements otherwise you will damage the spacers and we will not be able to accept any refunds.
- Be the first to review this product